Saturn Sky Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
208 Posts
Discussion Starter #1
Never done one before but hear it's not too hard. The one I need to take care of is on the rear. Just trying to get an idea if I have to disconnect the ebrake, take the caliper off, or anything else before I dig in.
 

·
Registered
Joined
·
771 Posts
Not (yet) on the Sky - but I kinda recall doing such to other GM's.

Does look like it has to be done on a bench though - not "on car"

Just need a Deep Well Socket (to create a hole for the stud) and large "C" Clamp to do the pressing??
 

·
Registered
Joined
·
701 Posts
My biggest issue was that 30mm (or maybe it was 35mm) axle nut. No amount of wrench was getting that sucker off for me. I ended up putting 3' of pipe over an 18" ratchet and still nearly killed myself. The rest of the project wasn't bad.
 
1 - 4 of 4 Posts
Top