Saturn Sky Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
93 Posts
Discussion Starter · #1 ·
It has been brought to my attention there is a concern about the warp in the header flange. The warp is absolutely normal. It results from the laser cutting process. There is no need for concern. If the instructions on tightening the nuts are followed exactly as I wrote them the header flange is pulled flat to the head without issue and without a chance of leaking. Under no circumstances should any relief slots be cut into our header flange! If this is done, both the warranty on our header and the warranty on the ceramic coating is void. No exceptions!
If there is a question during install or in general, about our header, please call! I tried to include as much info as possible when I wrote the install tips. I will edit them to mention the NORMAL warp in the header flange.

Any comments are welcome.
Thanks again!
 
1 - 1 of 1 Posts
Top